Download
Help

Troubleshooting

The most common problems and how to fix each one.

The controller isn't in the list

Check that it's on and the E-stop is released. Unplug the USB cable, wait 5 seconds and plug it back in. Try another USB port and a cable that carries data.

It says "The port is in use"

Another program is using the machine. Close gSender or any other connected program and try again.

It connected, but the machine won't move

It may have started locked: click Unlock. Check the E-stop (up and lit) and the motor cables.

The spindle doesn't spin in the test

AutoSpin: check it's plugged in and in Spindle mode. VFD showing r00.0 or F00.0: check the data cable at the back of the controller, then power both off and on.

The touch plate gave an alarm

The bit lowered without touching. Put the magnet on the bit, the plate under it, and measure again.

Limit alarm

The bit reached the edge of the machine. Unlock, find home again and check that the board fits the work area.

Ethernet won't connect

Check the port lights (solid green, blinking yellow), the computer's IP (192.168.5.x, never .1) and use a direct cable with no router.

Mac: "CarvCAM can't be opened" or "Apple could not verify"

This version isn't notarized by Apple yet. Click Done, then open System Settings › Privacy & Security and click Open Anyway next to the CarvCAM message. On macOS 14 and older you can also Control-click the app › Open. See Install on a Mac.

Mac: "CarvCAM is damaged" or it won't start

Check you downloaded the file for your chip: Apple Silicon for M1 and newer, Intel for Intel Macs (Apple menu › About This Mac). Download it again from the download page and drag it to Applications.

Linux: the controller is listed but won't open

Your user can't reach the USB port. With the .deb, unplug and replug the USB cable. With the AppImage, run sudo usermod -aG dialout $USER, then log out and back in.

Pro went back to free

CarvCAM couldn't confirm your plan for 30 days. Connect to the internet and open CarvCAM; Pro comes back on the next check. See Account and Pro.

Can I use CarvCAM without the machine?

Yes. In the connect wizard, choose Simulator. Everything works the same and the carve only happens on screen.

Still stuck?

Read Bit changes and alarms or go through Connect your machine again from the start.

Was this page helpful?