Set up a LongMill MK2
The LongMill MK2 runs on the LongBoard or the SuperLongBoard, usually with the Makita RT0701C. Connect it in this order.
| LongMill MK2 | |
|---|---|
| Work area | up to 48 × 30 in |
| Controller | LongBoard (grbl) or SuperLongBoard (grblHAL) |
| Connection | USB (LongBoard), USB-C or Ethernet (SuperLongBoard) |
| Spins the bit | Makita RT0701C (AutoSpin and spindle kits also supported) |
Wire it in this order
Power
24 V power supply into the LongBoard or SuperLongBoard.
Makita router
Makita: plugged into the wall, switch off until CarvCAM asks for it.
USB to the computer
USB cable straight into your computer (SuperLongBoard: USB-C or Ethernet).
Connect
Connect in CarvCAM and pick your controller; no homing sensors? You set zero by hand.

Makita speed
The Makita's speed is set by hand on its dial. CarvCAM shows the dial number for each cut before it starts.
Ready on day one
- 12×30, 30×30 and 48×30 work areas
- Makita dial number (1–6) for each operation
- Feeds and speeds for Sienci bits on your MK2
Connect wizardEvery step of the wizard, explained.USB or EthernetWhich cable to use.LongMill MK2 overviewSpecs, presets and guides.
Was this page helpful?Thanks for the feedback.