Bit changes and alarms
Two moments where CarvCAM stops and walks you through: a bit change and an alarm.
Change bits mid-job
The carve waits
When the next operation needs another bit, the machine stops and lifts. The screen shows which bit to put in.
Swap the bit
Change it, then measure the new one with the touch plate when asked.
Continue
CarvCAM restarts the spindle and carries on from the next operation.
After an alarm
| Alarm | What happened | What to do |
|---|---|---|
| Limit | The bit reached the edge of the machine | Unlock, find home again and check that the board fits the work area |
| Probe | The bit lowered without touching the plate | Put the magnet on the bit, the plate under it, and measure again |
| E-stop | The emergency stop was pressed | Twist the E-stop to release it, then Unlock |
| Lost connection | The cable came out or the controller lost power | CarvCAM shows it right away. Reconnect, home, and restart the operation |
Where it restarts
After an alarm, the operation restarts from its beginning, with the bit lifted to a safe height first.
Was this page helpful?Thanks for the feedback.