LongMill MK2 software: design, carve and control in one app
Thousands of MK2s are still carving. CarvCAM supports both of its controllers and the classic Makita router, including the one thing a manual router needs: the dial number for each cut, shown before you start.
| Work area | up to 48 × 30 in |
| Controller | LongBoard (grbl) or SuperLongBoard (grblHAL) |
| Connection | USB (LongBoard), USB-C or Ethernet (SuperLongBoard) |
| Spins the bit | Makita RT0701C (AutoSpin and spindle kits also supported) |
Connect your LongMill MK2 in four checks
24 V power supply into the LongBoard or SuperLongBoard.
Makita: plugged into the wall, switch off until CarvCAM asks for it.
USB cable straight into your computer (SuperLongBoard: USB-C or Ethernet).
Connect in CarvCAM and pick your controller; no homing sensors? You set zero by hand.

Already set for your LongMill MK2
- 12×30, 30×30 and 48×30 work areas
- Makita dial number (1–6) for each operation
- Feeds and speeds for Sienci bits on your MK2
Step-by-step guides

Make a wooden sign
From blank board to finished sign on a LongMill or AltMill: design, pick a speed, set zero with the touch plate, carve and finish. With screenshots.
Read the guide
V-carve a house number plaque
A step-by-step guide to a V-carved house number plaque: layout with text on an arc, V-bit setup, depth passes and finishing for outdoor use.
Read the guide
Set work zero with a touch plate
Set X, Y and Z zero on a LongMill or AltMill with the touch plate: where the zero goes, how the probe works, and how to check it before carving.
Read the guideOther machines: LongMill MK3 · AltMill · Best CNC software for LongMill
From blank board to finished sign.
One app for your LongMill or AltMill.