Download
Get started

How CarvCAM works

Every job follows the same four steps, always in this order. They sit at the top of the screen, and each one unlocks only when the one before it is ready.

StepWhat you do
1 · CreateDesign the sign and see the carved result before you start
2 · PreparePick a speed; CarvCAM makes the toolpaths and checks them
3 · PositionConnect, find home, clamp the board and set zero
4 · CarveWatch the carve, pause, and change bits when asked
The Workshop: projects ready for your machine. The active machine and the connection status are at the top.
The Workshop: projects ready for your machine. The active machine and the connection status are at the top.

How the parts connect

CarvCAM runs on your computer and talks directly to your machine's controller over USB or Ethernet. The controller drives the motors and switches the router or spindle on and off.

PartRole
CarvCAMDesign, toolpaths and machine control
Controller (LongBoard, SuperLongBoard, SLB-LITE, SLB-EXT)Runs the motors and reads the sensors
Router or spindleSpins the bit; the AutoSpin and spindles get their speed from CarvCAM
Touch plateMeasures where the bit tip is
No separate sender needed

Because CarvCAM also runs the machine, you don't need gSender or any other sender, you don't export G-code into another program, and there is no post-processor to pick. If you'd rather run a job from another sender, Download G-code (.nc) in Prepare saves the checked file.

Design in Claude

You can also describe a sign to Claude and it designs it with CarvCAM, showing these four steps in the chat. See Design with Claude.

Simple and Advanced view

In Prepare, Position and Carve, the Simple / Advanced switch in the top bar shows or hides the raw numbers: RPM, feed, plunge, depth per pass and stepover, plus the rulers. It only changes what you see, not what you can use.

Was this page helpful?