# USB or Ethernet | CarvCAM Docs

> When to connect your LongMill or AltMill over USB or Ethernet, and how to set up a direct Ethernet connection to the SuperLongBoard or SLB-EXT.

Source: https://carvcam.com/docs/usb-or-ethernet/

Connect

# USB or Ethernet

USB is the simplest and works with every controller. Ethernet is for the SuperLongBoard and SLB-EXT, when the computer is far from the machine or USB keeps dropping.

4 steps

| Cable | Choose it when | Controllers |
| --- | --- | --- |
| USB | You're starting out, or for most shops: just plug it in | All |
| Ethernet | The computer is far away, or USB disconnects | SuperLongBoard, SLB-EXT |

## Set up Ethernet

### 1. Check the controller's address
Connect once over USB and check the controller's IP address. The default is `192.168.5.1`.

### 2. Plug in the cable
Connect the cable straight from the computer to the controller, with no router in between.

### 3. Set your computer's address
In your network settings, give the Ethernet port the IP `192.168.5.5` and the subnet mask `255.255.255.0`.

### 4. Connect
In the wizard, choose Ethernet, enter `192.168.5.1` and click **Connect**. The port on the controller shows a solid green light and a blinking yellow one.

[Image: Connect in CarvCAM]

> **Warning: Never use .1 on the computer.** The computer's address must be different from the controller's: any `192.168.5.x` except `.1`.
