# Troubleshooting | CarvCAM Docs

> Fixes for the most common CarvCAM problems: the controller isn't listed, the port is in use, the machine won't move, the spindle won't spin, alarms, Ethernet, opening on a Mac, USB on Linux and Pro.

Source: https://carvcam.com/docs/troubleshooting/

Help

# Troubleshooting

The most common problems and how to fix each one.

## The controller isn't in the list
Check that it's on and the E-stop is released. Unplug the USB cable, wait 5 seconds and plug it back in. Try another USB port and a cable that carries data.

## It says "The port is in use"
Another program is using the machine. Close gSender or any other connected program and try again.

## It connected, but the machine won't move
It may have started locked: click **Unlock**. Check the E-stop (up and lit) and the motor cables.

## The spindle doesn't spin in the test
AutoSpin: check it's plugged in and in Spindle mode. VFD showing r00.0 or F00.0: check the data cable at the back of the controller, then power both off and on.

## The touch plate gave an alarm
The bit lowered without touching. Put the magnet on the bit, the plate under it, and measure again.

## Limit alarm
The bit reached the edge of the machine. Unlock, find home again and check that the board fits the work area.

## Ethernet won't connect
Check the port lights (solid green, blinking yellow), the computer's IP (`192.168.5.x`, never `.1`) and use a direct cable with no router.

## Mac: "CarvCAM can't be opened" or "Apple could not verify"
This version isn't notarized by Apple yet. Click **Done**, then open **System Settings › Privacy & Security** and click **Open Anyway** next to the CarvCAM message. On macOS 14 and older you can also Control-click the app › **Open**. See [Install on a Mac](https://carvcam.com/docs/install/).

## Mac: "CarvCAM is damaged" or it won't start
Check you downloaded the file for your chip: **Apple Silicon** for M1 and newer, **Intel** for Intel Macs (Apple menu › About This Mac). Download it again from the [download page](https://carvcam.com/download/) and drag it to Applications.

## Linux: the controller is listed but won't open
Your user can't reach the USB port. With the .deb, unplug and replug the USB cable. With the AppImage, run `sudo usermod -aG dialout $USER`, then log out and back in.

## Pro went back to free
CarvCAM couldn't confirm your plan for 30 days. Connect to the internet and open CarvCAM; Pro comes back on the next check. See [Account and Pro](https://carvcam.com/docs/account-and-pro/).

## Can I use CarvCAM without the machine?
Yes. In the connect wizard, choose **Simulator**. Everything works the same and the carve only happens on screen.

> **Note: Still stuck?.** Read [Bit changes and alarms](https://carvcam.com/docs/bit-changes-and-alarms/) or go through [Connect your machine](https://carvcam.com/docs/connect/) again from the start.
