# Safety and your first carve | CarvCAM Docs

> Protective gear, a first-carve checklist with an air cut, and what to do when in doubt: stop first.

Source: https://carvcam.com/docs/safety/

Help

# Safety and your first carve

A CNC cuts wood, plastic and fingers the same way. Follow these rules every time, and with extra care on your first carves.

| Wear | Why |
| --- | --- |
| Safety glasses | Always, even for an air cut |
| Hearing protection | Routers and dust collectors are loud |
| Hair tied, no loose sleeves or gloves near the bit | So nothing gets pulled in |
| Stay at the machine, E-stop within reach | For the whole carve |

## First carve checklist

- Glasses and hearing protection on
- Other machine programs closed
- Connect wizard finished: the Z lifted and the spindle spun
- Find home: the machine went to the back-right corner
- Arrow keys: the screen follows the machine both ways
- Touch plate: the bit touched, stopped and lifted
- Air cut: zero about 10 mm above the board (or the board off) and run a small job
- During the air cut, test Pause, Resume and Stop
- Compare the movement with the preview: position and size
- Then cut a scrap piece and measure it

> **Note: CarvCAM asks before the first carve.** The first time you press **Start carving** on each machine over a real USB or Ethernet connection, CarvCAM asks you to confirm the air cut, your hand on the E-stop and a clear path. **Start carving** stays disabled until all three are ticked, and it's asked once per machine. See [Run the carve](https://carvcam.com/docs/carve/).

> **Warning: When in doubt, stop first.** Press **Esc** or **Stop**. If the machine doesn't stop, press the **E-stop**. Only carve again once you know what happened.
