# Quickstart: carve your first sign | CarvCAM Docs

> Go from a blank board to a carved sign on your LongMill or AltMill in about 15 minutes of setup. Five steps, with screenshots.

Source: https://carvcam.com/docs/quickstart/

Get started

# Quickstart: carve your first sign

Five steps from a blank board to a carved sign. Each step links to the full page if you want more detail.

5 steps · about 15 min

> **Note: Before you start.** You need CarvCAM installed, your machine assembled, a board clamped nearby, a bit in the router and the touch plate. No machine yet? Pick **Simulator** in step 3 and follow along.

[Video: The whole flow in 35 seconds.]

The whole flow in 35 seconds.

### 1. Design the sign
Open **Create**, click **+ Text** and type your words. Pick a font and drag **Letter height** until the text fills the board. See [The Create screen](https://carvcam.com/docs/create/).

[Image: Design the sign in CarvCAM]

### 2. Prepare the cut
Click **Continue to Prepare** and choose **Balanced**. Check the time and the board size in the summary. See [Prepare the carve](https://carvcam.com/docs/prepare/).

[Image: Prepare the cut in CarvCAM]

### 3. Connect the machine
Click **Not connected** at the top. Follow the cable checks, pick your controller and press **Connect**. The Z lifts 2 mm and the bit spins for 3 seconds to prove it works. See [Connect your machine](https://carvcam.com/docs/connect/).

[Image: Connect the machine in CarvCAM]

### 4. Home, clamp and zero
In **Position**, click **Find home**, clamp the board, press **Measure height** with the touch plate and set zero on the bottom-left corner. See [Home, clamp and set zero](https://carvcam.com/docs/position/).

[Image: Home, clamp and zero in CarvCAM]

### 5. Carve
Tick the checklist, put your glasses on and press **Start carving**. Space pauses, Esc stops. See [Run the carve](https://carvcam.com/docs/carve/).

[Image: Carve in CarvCAM]

> **Warning: First time on this machine?.** Do an air cut first: set work zero about 10 mm above the board (or take the board off) and run a small job. The first time you press **Start carving** on each machine, CarvCAM asks you to confirm the air cut, a hand on the E-stop and a clear path before it moves. Read the [first carve checklist](https://carvcam.com/docs/safety/).

[**Set up your workshop** Tell CarvCAM your machine, router and bits.](https://carvcam.com/docs/workshop/)[**Cut styles** Raised, Engraved, V-carve, Cut through and Part.](https://carvcam.com/docs/cut-styles/)[**Troubleshooting** Fixes for the most common problems.](https://carvcam.com/docs/troubleshooting/)
