# Prepare the carve | CarvCAM Docs

> Pick Fast, Balanced or Detailed, set holding tabs and a second bit, check time and verified G-code, print a setup sheet, then go to Position or download the G-code.

Source: https://carvcam.com/docs/prepare/

Prepare

# Prepare the carve

Prepare turns the design into the path of the bit, with feeds and speeds for your machine, and checks the result before it lets you near the machine.

5 steps

[Video: Play the toolpath and switch to 3D.]

Play the toolpath and switch to 3D.

### 1. Pick a speed
Under **Speed**, choose Fast, Balanced or Detailed (see the table below). Each one shows its time. Values come from Sienci's speed table for your machine and bit.

### 2. Check tabs and bits
If the job cuts parts out, check **Holding tabs**. If fine details need a smaller bit, turn on **Second bit**.

### 3. Check time and G-code
**Time & G-code** lists the time, the bits, the Makita dial for each cut and the board needed. **G-code verified** means the file passed CarvCAM's checks. **Print setup sheet** gives you a one-page summary for the machine.

[Image: Check time and G-code in CarvCAM]

### 4. Preview
**Play toolpath** animates the bit (orange is where the bit goes). Switch to 3D to see the finished piece.

### 5. Continue
**Continue to Position →** takes you to the machine.

## Which speed to use

| Option | Sienci table | When to use it |
| --- | --- | --- |
| Fast | Maximum | Soft wood and simple shapes; edges may need a bit more sanding |
| Balanced | Regular | Most signs: good finish in reasonable time |
| Detailed | Reduced | Small letters and the cleanest edges |

## Two bits

Turn on **Second bit** when fine details need a smaller bit. CarvCAM engraves the details with the finer bit and the rest with the larger one, and asks for the change in the middle of the carve.

## Other ways to run the job

CarvCAM runs the machine itself, so you don't need another program. If you still want one, **Download G-code (.nc)** under **Continue to Position** saves the verified file, for another sender (gSender included) or a USB stick.

> **Note: No post-processor to pick.** The G-code is written for the controller in your machine profile (LongBoard, SuperLongBoard, SLB-LITE or SLB-EXT) and checked line by line: travel, depth, bits, feeds and spindle range.

[**Bits and feeds** Where the numbers come from.](https://carvcam.com/docs/bits-and-feeds/)[**Batch and pricing** One file per row of a spreadsheet, and what to charge.](https://carvcam.com/docs/batch-and-pricing/)
