# Home, clamp and set zero | CarvCAM Docs

> Find home, clamp the board, mark clamps as keep-out zones, measure the bit with the touch plate or by hand, and set work zero on the bottom-left corner of the board.

Source: https://carvcam.com/docs/position/

Position & carve

# Home, clamp and set zero

Position takes the machine from "I don't know where I am" to "I know exactly where your board is". The bed is on the left, seen from above; the steps are on the right.

4 steps

### 1. Find home
Click **Find home**. The machine moves to the back-right corner, touches its sensors and stops. It takes about 30 seconds; keep the bed clear.

[Image: Find home in CarvCAM]

### 2. Clamp the board
The screen shows the minimum board size. Clamp it anywhere on the bed, with at least 10 mm of margin around the sign, and click **My board is clamped**. Optionally mark the clamps as [keep-out zones](https://carvcam.com/docs/keep-out-and-setup-sheet/).

[Image: Clamp the board in CarvCAM]

### 3. Measure the bit
With the touch plate (recommended): put the plate on the board under the bit, clip the magnet on the bit and press **Measure height**. The bit lowers until it touches, measures, and lifts 5 mm.

[Image: Measure the bit in CarvCAM]

### 4. Set zero
Click the bottom-left corner of the board on the screen to move there, fine-tune with the arrows (PageUp and PageDown for Z), then **Set zero here**.

[Image: Set zero in CarvCAM]

> **Note: Where zero is.** On the bottom-left corner of the board, on its top face. The design is carved from there.

> **Tip: No touch plate?.** Choose **Set Z by hand (paper method)**: put a sheet of paper on the board, lower the bit in 1 mm, then 0.1 mm, then 0.01 mm steps until it just pinches the paper, and click **Set Z zero here**.

> **Tip: No limit switches?.** Click **My machine has no limit sensors**: jog to the back-right corner by hand and set it as home.
