# Set up a LongMill MK3 | CarvCAM Docs

> Wire and connect a LongMill MK3 with the SLB-LITE controller and AutoSpin T1 to CarvCAM, step by step.

Source: https://carvcam.com/docs/longmill-mk3/

Connect

# Set up a LongMill MK3

The LongMill MK3 comes with the SLB-LITE controller and the AutoSpin T1. Connect it in this order.

4 steps

| | LongMill MK3 |
| --- | --- |
| Work area | 32 × 32 in or 49 × 32 in |
| Controller | SLB-LITE (grblHAL) |
| Connection | USB-C |
| Spins the bit | AutoSpin T1 router (Makita and spindle kits also supported) |

## Wire it in this order

### 1. Power
Power supply into the SLB-LITE, switch on, release the E-stop.

### 2. AutoSpin T1
AutoSpin T1: signal cable into the SPINDLE port (the phone-style jack), router in Spindle mode.

### 3. USB-C to the computer
USB-C from the controller straight into your computer.

### 4. Connect and test
Connect in CarvCAM: it reads the controller, unlocks it and runs a 2 mm Z test and a 3 second spindle test.

[Image: The connect wizard knows the SLB-LITE and the AutoSpin T1 of your MK3.]

The connect wizard knows the SLB-LITE and the AutoSpin T1 of your MK3.

## Ready on day one

- Work area and Z travel of the 30×30 and 48×30
- AutoSpin T1 speed range (10,000–30,000 RPM), set by the program
- Feeds and speeds for Sienci bits on your MK3

[**Connect wizard** Every step of the wizard, explained.](https://carvcam.com/docs/connect/)[**USB or Ethernet** Which cable to use.](https://carvcam.com/docs/usb-or-ethernet/)[**LongMill MK3 overview** Specs, presets and guides.](https://carvcam.com/machines/longmill-mk3/)
