# Set up a LongMill MK2 | CarvCAM Docs

> Wire and connect a LongMill MK2 with the LongBoard or SuperLongBoard and a Makita router to CarvCAM, step by step.

Source: https://carvcam.com/docs/longmill-mk2/

Connect

# Set up a LongMill MK2

The LongMill MK2 runs on the LongBoard or the SuperLongBoard, usually with the Makita RT0701C. Connect it in this order.

4 steps

| | LongMill MK2 |
| --- | --- |
| Work area | up to 48 × 30 in |
| Controller | LongBoard (grbl) or SuperLongBoard (grblHAL) |
| Connection | USB (LongBoard), USB-C or Ethernet (SuperLongBoard) |
| Spins the bit | Makita RT0701C (AutoSpin and spindle kits also supported) |

## Wire it in this order

### 1. Power
24 V power supply into the LongBoard or SuperLongBoard.

### 2. Makita router
Makita: plugged into the wall, switch off until CarvCAM asks for it.

### 3. USB to the computer
USB cable straight into your computer (SuperLongBoard: USB-C or Ethernet).

### 4. Connect
Connect in CarvCAM and pick your controller; no homing sensors? You set zero by hand.

[Image: The power step of the connect wizard.]

The power step of the connect wizard.

> **Tip: Makita speed.** The Makita's speed is set by hand on its dial. CarvCAM shows the dial number for each cut before it starts.

## Ready on day one

- 12×30, 30×30 and 48×30 work areas
- Makita dial number (1–6) for each operation
- Feeds and speeds for Sienci bits on your MK2

[**Connect wizard** Every step of the wizard, explained.](https://carvcam.com/docs/connect/)[**USB or Ethernet** Which cable to use.](https://carvcam.com/docs/usb-or-ethernet/)[**LongMill MK2 overview** Specs, presets and guides.](https://carvcam.com/machines/longmill-mk2/)
