# Keep-out zones and the setup sheet | CarvCAM Docs

> Mark clamps and screws as keep-out zones so the bit avoids them and travels over them at a safe height, and print a one-page setup sheet to take to the machine.

Source: https://carvcam.com/docs/keep-out-and-setup-sheet/

Position & carve

# Keep-out zones and the setup sheet

Two free tools for a safer carve: keep-out zones tell CarvCAM where your clamps are, and the setup sheet puts the whole job on one printed page.

3 steps

## Clamps and keep-out zones

In **Position**, open **Clamps & keep-out zones** (optional). Mark where your clamps or screws sit; CarvCAM keeps the bit out of them and travels over them at a safe height.

### 1. Draw a zone
Click **Draw a zone** and drag on the board where the clamp is.

[Image: Draw a zone in CarvCAM]

### 2. Fine-tune
Name it and set **X**, **Y**, **Width**, **Depth** and **Clamp height**. X and Y are the bottom-left corner of the zone, measured from work zero; height is how far it sticks up above the board.

### 3. Check
If a cut would hit a zone, it's marked **Error · blocks carving** and Prepare tells you to move the clamp or the design.

## Setup sheet

In **Prepare › Time & G-code**, click **Print setup sheet**. It fits one A4 or Letter page and shows:

- The board size and material, and where zero goes
- A drawing of the job with the clamps you marked
- Each bit in order with feed, plunge, depth per pass, stepover and RPM or Makita dial
- The holding tabs
- A checklist: board clamped, zero set, dial or spindle, dust collection, eye and ear protection
- Whether the G-code was verified

[Image: The setup sheet, ready to print.]

The setup sheet, ready to print.
