# Connect your machine | CarvCAM Docs

> The CarvCAM connect wizard shows where each cable goes, connects over USB or Ethernet, and proves the machine responds with a Z move and a spindle test.

Source: https://carvcam.com/docs/connect/

Connect

# Connect your machine

The connect wizard shows where every cable goes, connects, and proves that the machine really responds. Open it from **Not connected** at the top of the screen.

4 steps

> **Warning: Close other machine programs first.** CarvCAM connects to the controller itself; you don't need gSender. Only one program can use the connection, so if gSender or another sender is connected, close it first.

[Video: Cable by cable, then a real test.]

Cable by cable, then a real test.

### 1. Start
The wizard already knows the controller that comes with your machine. Choose **Show me the cables**, or **Everything is already plugged in**.

[Image: Start in CarvCAM]

### 2. Follow the cable map
A drawing of your setup is on the left. Each step says what to do, how to know it worked, and what to try if it didn't. Tick the confirmation to move on.

[Image: Follow the cable map in CarvCAM]

### 3. Pick the controller
It appears in the list a few seconds after you plug in the cable. Select it and click **Connect**.

[Image: Pick the controller in CarvCAM]

### 4. Prove it works
CarvCAM checks the controller's reply. Then the Z lifts 2 mm and the bit spins for 3 seconds. Answer **Yes** to each. If the machine started locked, click **Unlock**.

[Image: Prove it works in CarvCAM]

## Cable map colors

| Color | Meaning |
| --- | --- |
| Orange | The cable to connect now |
| Green | Already connected |
| Gray | Next steps |

## How the app reaches the controller

The desktop app has a small built-in connector that opens the USB port or the Ethernet connection; nothing else to install. It only accepts connections from CarvCAM on your own computer. On Linux, USB access comes with the .deb; with the AppImage, join the dialout group once ([Install](https://carvcam.com/docs/install/)).

> **Tip: No machine yet?.** Choose **Simulator** in the list: every step works the same and the carve only happens on screen.

> **Tip: Next time is faster.** CarvCAM remembers your setup and goes straight to the connection with **Everything is already plugged in**. The cable map stays available.

[**USB or Ethernet** Which one to use and how to set up Ethernet.](https://carvcam.com/docs/usb-or-ethernet/)[**Your machine** Wiring for LongMill MK3, MK2 and AltMill.](https://carvcam.com/docs/longmill-mk3/)
