# Run the carve | CarvCAM Docs

> The pre-carve checklist, what you can do during the carve (pause, stop, speed overrides) and how to finish the piece.

Source: https://carvcam.com/docs/carve/

Position & carve

# Run the carve

Before you start, a checklist has to turn green: size, zero, bit, speed and hold-down. Then you watch.

6 steps

[Video: Start, watch the live preview, change the bit when asked, and the finished piece.]

Start, watch the live preview, change the bit when asked, and the finished piece.

### 1. Check the list
Fix anything marked. For the bit, confirm with **It's in** once it's installed.

[Image: Check the list in CarvCAM]

### 2. Start
Glasses on, then **Start carving**. On the first carve with each machine, confirm the safety steps first (below).

### 3. Watch
The preview carves on screen together with the machine. The panel shows progress, time left and the current operation.

[Image: Watch in CarvCAM]

## First carve on each machine

CarvCAM talks to the controller directly, with no other sender in between. So the first time you press **Start carving** with a machine connected over USB or Ethernet, a **First carve on this machine** dialog asks you to tick three things:

| Tick | Why |
| --- | --- |
| Air cut first: set work zero about 10 mm above the board (or take the board off) | The first run cuts nothing, so a wrong move costs nothing |
| Hand on the E-stop, and you know **Esc** or **Stop** halts the machine | If a move looks wrong, you can stop it at once |
| Clamps, cables and hands clear of the bit's path, eye protection on | Nothing in the way of the first moves |

**Start carving** stays disabled until all three are ticked. **Set zero higher first** takes you back to Position to raise the zero. The dialog is asked once per machine; the Simulator never asks. You can always download the G-code in Prepare and run it in another sender instead.

## During the carve

| You want to | Do this |
| --- | --- |
| Pause | Press the space bar or **Pause**. **Resume** continues from the same point |
| Stop | Press Esc or **Stop**. Everything stops safely and the position is kept |
| Go faster or slower | Move **Feed speed** or **Bit rotation**, from 50% to 150% |

## Finish the piece

### 1. Clean up
Vacuum the dust and lift the board off the bed.

[Image: Clean up in CarvCAM]

### 2. Cut the tabs
Use a flush-cut saw or a utility knife and pop the piece out.

### 3. Sand
Sand the edges and the tab marks with 120, then 220 grit.
