# Bits and feeds | CarvCAM Docs

> CarvCAM's Sienci bit library: every bit in Sienci's eight sets, I have this set, filters, collet fit, and where official and estimated feeds and speeds come from.

Source: https://carvcam.com/docs/bits-and-feeds/

Prepare

# Bits and feeds

CarvCAM knows every Sienci Labs bit. Mark the ones you own in **My bits** and every job uses them with numbers for your machine and router.

3 steps

[Image: My bits: the Sienci library, with feeds for your machine.]

My bits: the Sienci library, with feeds for your machine.

## Mark the bits you own

### 1. Open My bits
Menu at the top left › **My bits**. **My bits** shows yours; **All Sienci bits** shows the whole catalog.

### 2. Add a whole set
Choose your set in **Sienci set**, then **I have this set**. Every bit in it is added.

### 3. Or bit by bit
**Add to my bits** on a card. **Remove from my bits** takes it out; the card stays until you leave, with **Add back**.

## The Sienci sets

| Sold for | Sets |
| --- | --- |
| LongMill | Starter End Mill Set, Sign Maker End Mill Set, 3D Carver End Mill Set, Machinists End Mill Set |
| AltMill | AltMill Starter Set, AltMill Pro Set, AltMill Sign Maker Set, AltMill Chamfer Set |

The sets sold for your machine are listed first. Filter cards by use (**Engrave**, **Relief**, **Cut out**, **Plastic**, **Surface**) and pick the material in **Feeds for**: soft wood, plywood and MDF; hardwood; plastics; or aluminum 6061.

## What a bit card tells you

- Type, cutting diameter, cut length and shank
- Whether it fits your router or spindle, or needs the 1/8″ collet
- Which Sienci sets it comes in
- Feed, RPM (with the Makita dial) and depth per pass for your machine, router and the material you picked
- A link to the bit at Sienci Labs

## Official or estimated feeds

| Badge | Means |
| --- | --- |
| **Official Sienci feeds** | Sienci's own numbers from its Feeds & Speeds table, unchanged, for a LongMill with a router or spindle that reaches the RPM |
| **Estimated** | Worked out from that same table: the AltMill uses the LongMill table, as Sienci advises; bits the table doesn't list start from the closest bit and keep the same chip load per diameter; the RPM is held to what your router can do and the feed drops to match; nothing goes above your machine's max speed |
| Not recommended | A combination Sienci leaves out of its table, such as surfacing plastic. CarvCAM tells you why |

Hover a badge in the app to see the reason for that bit. Fast, Balanced and Detailed in [Prepare](https://carvcam.com/docs/prepare/) use the Maximum, Regular and Reduced columns of the table.

> **Note: More from the Sienci store.** Bits for 3D carving, roughing, bowls and big surfacing are listed with their feeds, but CarvCAM doesn't plan toolpaths for them yet.

> **Warning: Test on scrap.** Feeds are a starting point. Always test a new bit or material on scrap first.
