# Bit changes and alarms | CarvCAM Docs

> How CarvCAM guides a bit change in the middle of a job, and what to do after an alarm or a lost connection.

Source: https://carvcam.com/docs/bit-changes-and-alarms/

Position & carve

# Bit changes and alarms

Two moments where CarvCAM stops and walks you through: a bit change and an alarm.

3 steps

## Change bits mid-job

### 1. The carve waits
When the next operation needs another bit, the machine stops and lifts. The screen shows which bit to put in.

### 2. Swap the bit
Change it, then measure the new one with the touch plate when asked.

### 3. Continue
CarvCAM restarts the spindle and carries on from the next operation.

## After an alarm

| Alarm | What happened | What to do |
| --- | --- | --- |
| Limit | The bit reached the edge of the machine | Unlock, find home again and check that the board fits the work area |
| Probe | The bit lowered without touching the plate | Put the magnet on the bit, the plate under it, and measure again |
| E-stop | The emergency stop was pressed | Twist the E-stop to release it, then Unlock |
| Lost connection | The cable came out or the controller lost power | CarvCAM shows it right away. Reconnect, home, and restart the operation |

> **Note: Where it restarts.** After an alarm, the operation restarts from its beginning, with the bit lifted to a safe height first.
