# Set up an AltMill | CarvCAM Docs

> Wire and connect an AltMill with the SLB-EXT controller and the ER20 spindle and VFD to CarvCAM, step by step.

Source: https://carvcam.com/docs/altmill/

Connect

# Set up an AltMill

The AltMill runs on the SLB-EXT with a 2.2 kW or 1.5 kW ER20 spindle and its VFD. Connect it in this order.

4 steps

| | AltMill |
| --- | --- |
| Work area | 49 × 25 in, 49 × 49 in or 49.8 × 104 in |
| Controller | SLB-EXT (grblHAL) |
| Connection | USB-C or Ethernet |
| Spins the bit | 2.2 kW or 1.5 kW ER20 spindle with VFD |

## Wire it in this order

### 1. Power
48 V power supply into the SLB-EXT, switch on, release the E-stop.

### 2. Spindle and VFD
Spindle cable into the VFD; VFD data cable into the back of the controller, above the power switch.

### 3. Power order
VFD on first (2.2 kW needs a 240 V outlet), then the controller.

### 4. Connect and test
USB-C or Ethernet to your computer, then Connect: CarvCAM proves the Z moves and the spindle spins.

[Image: The spindle and VFD step of the connect wizard.]

The spindle and VFD step of the connect wizard.

> **Warning: Power order.** Switch the VFD on before the controller. The 2.2 kW spindle needs a 240 V outlet.

## Ready on day one

- 2×4, 4×4 and 4×8 work areas
- ER20 spindle speed range (7,500–24,000 RPM) through the VFD
- Feeds and speeds for Sienci bits on the AltMill

[**Connect wizard** Every step of the wizard, explained.](https://carvcam.com/docs/connect/)[**USB or Ethernet** Which cable to use.](https://carvcam.com/docs/usb-or-ethernet/)[**AltMill overview** Specs, presets and guides.](https://carvcam.com/machines/altmill/)
